Roof Opening Panel Glass
WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Open the roof opening panel to the VENT position.
- Remove the 4 roof opening panel glass screws.
- To access the glass screws, unclip the top portion of the concertina blind and position aside as shown.
- To install, tighten to 6 N.m (53 lb-in).
- To install, reverse the removal procedure.
- Verify that the roof opening panel is centered and aligned before tightening the screws. For additional information, refer to ROOF OPENING PANEL ALIGNMENT .
- Initialize the roof opening panel motor. For additional information, refer to ROOF OPENING PANEL MOTOR INITIALIZATION .