AK8: Check Wire Between Low Oil Level Relay & Low Oil Level Sensor

With the ignition key in the OFF position, disconnect the low oil level relay connector and the low oil level sensor connector. Measure the resistance of the Black/Red wire between the low oil level relay connector and the low oil level sensor connector. See WIRING DIAGRAMS  . Measure the resistance of the Black/Red wire between the low oil level relay connector and ground. Is the resistance less than 5 ohms between the low oil level relay and the low oil level sensor, and greater than 10,000 ohms between the low oil level relay and ground? If yes, replace the low oil level relay. If no, service the Black/Red wire.