Transmission Overheating

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Failure Mode Effect Management may be enabled, refer to Routine 266 .

DIAGNOSTIC ROUTINES - TRANSMISSION OVERHEATING

Possible Component	Reference/Action
260 - ROUTINE
Powertrain Control System
PCM (gasoline engines), Transmission Control Module (TCM) (diesel engines), vehicle wiring harnesses, Pressure Control Solenoid A (PCA), Torque Converter Clutch (TCC) solenoid	Carry out On-Board Diagnostic (OBD) tests. Refer to the INTRODUCTION - GASOLINE MODELS for diagnosis and testing of the PCM. For gasoline engines, GO to PINPOINT TEST A and GO to PINPOINT TEST E . For diesel engines, GO to PINPOINT TEST F and GO to PINPOINT TEST J . Repair as required. Clear the DTCs, road test and rerun OBD test.
Transmission Fluid
Incorrect level	Check transmission fluid level and adjust as necessary. Refer to PRELIMINARY INSPECTION .
Condition	Carry out Transmission Fluid Condition Check. Refer to PRELIMINARY INSPECTION .
Transmission External Remote Filter
	Inspect for leakage. If damaged, repair as necessary.
Fluid Pump Assembly
Bolts not tightened to specification	Tighten to specification.
Gasket damaged	Inspect for damage. If damaged, install a new gasket.
Porosity, cross leaks, cup plug missing, plugged hole gears cracked or seized	Inspect for damage. If damaged, repair as necessary.
Control valves and springs or seal damaged, misassembled or stuck	If damaged or parts are missing, install a new seal or pump assembly. If misassembled, reassemble correctly.
Transmission Case
Case vent damaged	Inspect for damage. If damaged, repair as necessary.
Torque Converter
Torque converter One-Way Clutch (OWC) seized	Remove the transmission. Inspect for damage. Refer to TORQUE CONVERTER CONTAMINATION INSPECTION . If the torque converter fails to pass the criteria for replacement or is damaged, install a new or remanufactured torque converter.
Excessive torque converter slip detected	Remove the transmission. Inspect for damage. Refer to TORQUE CONVERTER CONTAMINATION INSPECTION . If the torque converter fails to pass the criteria for replacement or is damaged, install a new or remanufactured torque converter.
Other
Restriction in transmission cooling system	Check transmission cooling system efficiency. Refer to TRANSAXLE/TRANSMISSION COOLING .
Excessive trailer tow load	Refer to the appropriate towing manual .
Engine driveability concerns	Check engine driveability concerns. Refer to ELECTRONIC ENGINE CONTROLS - GASOLINE ENGINES and ELECTRONIC ENGINE CONTROLS DIESEL ENGINE .
Vehicle heat shields missing or damaged	Inspect for damage. If damaged, repair as necessary.
Vehicle air flow restricted	Inspect for damage. If damaged, repair as necessary.