Remove/Install Elastomer Bearing Of Strut Rod - AR33.15-P-0162S
Model 214
with code 480 (Self-levelling suspension)
Model 214
with code 489 (AIRMATIC Dual Control/semi-active air suspension)
Model 223
except code Z07 (B7 armoring on special protection version)
Shown on model 223 with code M005 (Vehicles with 4-MATIC/all-wheel drive) on right tension strut (2)
Shown on model 223 except code M005 (Vehicles with 4-MATIC/all-wheel drive) on right tension strut (2)
Shown on model 223 with code M005 (Vehicles with 4-MATIC/all-wheel drive) on left tension strut (2)
Shown on model 223 except code M005 (Vehicles with 4-MATIC/all-wheel drive) on left tension strut (2)
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Notes on repair work on suspension components | AH00.00-P-0100-01A | ||
| Remove | |||
| 1 | Remove corresponding tension strut (2). | Model 214 with code 480 (Self-levelling suspension) Model 214 with code 489 (AIRMATIC Dual Control/semi-active air suspension) |
AR33.15-P-0160WT |
| Model 223 except code Z07 (B7 armoring on special protection version) |
AR33.15-P-0160S | ||
| 2.1 | Replace elastomer bearing (1). | If an elastomer bearing (1) for caster correction is installed. The arrow on the elastomer bearing (1) must always face towards the wheel side. Otherwise, it may cause damage or malfunction. Ensure that bar (arrow a) is positioned correctly. Otherwise it may cause damage or malfunction. |
AR33.15-P-0163-01S |
| Fig 1 | |||
| Fig 2 | |||
| 2.2 | Install new tension strut (2). | If an elastomer bearing (1) without caster correction (A) is installed. | |
| Install | |||
| 3 | Install tension strut (2). | Model 214 with code 480 (Self-levelling suspension) Model 214 with code 489 (AIRMATIC Dual Control/semi-active air suspension) |
AR33.15-P-0160WT |
| Model 223 except code Z07 (B7 armoring on special protection version) |
AR33.15-P-0160S |