Remove/Install Front Axle Outer Steering Tie Rod Joint - AR46.40-P-0211S
Model 223
Shown on left side of vehicle except code Z07 (B7 armoring for special protection version)
Fig 1: Front Axle Outer Steering Tie Rod Joint Components Location - Model 223 (Shown On Left Side Except Code Z07)
| Notice | Notes on threaded connections fastened using a tightening angle-based tightening process | AH00.00-P-0020-01A | |
| Notice | Notes on self-locking nuts and bolts | AH00.00-P-0001-01KOA | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Note on calculation of tightening torque when using insertion or socket tools with various effective lengths | AH00.00-P-0015-01CW | ||
| Remove/install | |||
| 1 | Remove corresponding front wheel. | AR40.10-P-1102A | |
| 2 | Counterhold tie rod joint (1) and release counternut (3). | Always counterhold tie rod joint (1). Otherwise, the tie rod joint (1) will be damaged. |
|
| *BA46.40-P-1002-01M | |||
| 3 | Remove nut (2). | The ball head must be counterheld and an impact wrench/driver must not be used. Otherwise the ball head or steering knuckle may be damaged. |
|
| *BA46.40-P-1001-01M | |||
| 4 | Remove tie rod joint (1) from steering knuckle | with code Z07 (B7 armoring on special protection version) Spindle |
Fig 3 |
with code Z07 (B7 armoring on special protection version) Puller |
Fig 2 | ||
| 5 | Remove tie rod joint (1) from inner tie rod (4). | ||
| 6 | Install in the reverse order. | ||
| Measure | |||
| 7 | Perform chassis alignment. | AR40.20-P-0200S |
TIE ROD
| Number | Designation | Model 223 | ||
|---|---|---|---|---|
| BA46.40-P-1001-01M | Nut, tie rod to steering knuckle | Stage 1 | Nm | 90 |
| Stage 2 | ∠° | 90 | ||
TIE ROD
| Number | Designation | Model 223 | |
|---|---|---|---|
| BA46.40-P-1002-01M | Jam nut, tie rod to inner tie rod | Nm | 65 |