Remove/Install Charge Air Pressure Sensor Downstream Of Throttle Valve Actuator - AR07.04-P-0101SVZ
Engine 279 in model 223
Shown with removed holders (1, 4)
| Topical note | Notes on avoiding damage through contamination and foreign objects | AH00.00-P-5000-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install | |||
| 1 | Remove engine cover. | AR01.10-P-2405SVZ | |
| 2 | Remove left and right air filter housing. | Remove/install left air filter housing | AR09.10-P-1151SVZ |
| Remove/install right air filter housing | AR09.10-P-1152SVZ | ||
| 3 | Remove the fuel tank bleed valve (Y58/9). | AR47.30-P-8252SVZ | |
| 4 | Remove screws (2) and release holder (1). | ||
| 5 | Remove screws (3) and release holder (4). | ||
| 6 | Raise the holders (1, 4) together. | ||
| 7 | Release and disconnect the electrical connector (5). | ||
| 8 | Remove screws (6) and take out the charge air pressure sensor (B28/7). | Lubricant, rubber assembly 1 L |
*BR00.45-Z-1010-06A |
| Fig 1 | |||
| Check | |||
| 9 | Check charge air pressure sensor (B28/7) and O-ring (7) for damage and wear. | If damage or wear is present: ↓ Replace the charge air pressure sensor (B28/7). |
|
| 10 | Install in the reverse order. | ||
| Check | |||
| 11 | Read out and delete fault memory using diagnostic system. | ||
| AD00.00-P-2000-06FR | |||
| Risk of burn injuries , suffocation and poisoning when working on the exhaust system and the components connected to it. Risk of suffocation and risk of poisoning caused by inhalation of gaseous and solid components of the exhaust. Risk of poisoning caused by skin contact with solid components of the exhaust. | Wear protective clothing and safety glasses. Use the extraction system. Move people out of the hazard area. | AS49.00-Z-0001-01A | |
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 12 | Carry out engine test run and check engine for proper operation and leak tightness. |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1010-06A | Lubricant, rubber assembly 1 L | A 000 989 03 67 |