Remove/Install Purge Line From Purge Control Valve To Charge-Air Distributor - AR47.30-P-0001S
Model 223 with Engine 256
Shown on Engine 256.9
| Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contact with fuel. | No fires, sparks, open flames or smoking. Pour fuels into suitable and appropriately marked containers only. Wear protective clothing when handling fuel. |
AS47.00-Z-0001-01A | |
| Risk of injury to skin and eyes suffering scalding from contact with hot coolant spray. Risk of poisoning from swallowing coolant. | Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the overpressure. Do not pour coolant into beverage containers. Wear protective gloves, protective clothing and safety glasses. |
AS20.00-Z-0001-01A | |
| Risk of injury . Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Notice | Notes on coolant | AH20.00-P-2080-01KOA | |
| Notice | Notes on avoiding damage through contamination and foreign objects | AH00.00-P-5000-01A | |
| Remove/install | |||
| 1 | Remove air filter housing. | AR09.10-P-1150SB | |
| 2 | Drain off low-temperature circuit coolant. | AR20.00-P-1144SB | |
| 3 | Remove purge valve. | AR47.30-P-8252S | |
| 4 | Remove coolant hoses from charge-air distributor. | AR20.20-P-7441-01RQ | |
| Fig 2 | |||
| 5 | Release and disconnect the electrical connector (2). | ||
| 6 | Remove retaining clip (3) from the purge line (1). | Fig 1 | |
| 7 | Unscrew screw (4). | *BA09.41-P-1014-01MRT | |
| 8 | Remove purge line (1). | Fig 2 | |
| 9 | Install in the reverse order. |
CHARGE AIR PIPE/CHARGE AIR COOLING
| Number | Designation | Engine 256 | |
|---|---|---|---|
| BA09.41-P-1014-01MRT | Screw, tank regeneration to charge-air distributor | Nm | 8 |