Remove/Install Front Door Panel - AR72.10-P-6575S
Model 223
Shown on model 223 except code Z07 (B7 Armoring for special protection version)
Shown on model 223 with code Z07 (B7 Armoring for special protection version)
| Notice | Notes on avoiding damage to windows installed in special high-security vehicles | Model 223 with code Z07 (B7 armoring on special protection version) |
AH67.00-P-0003-01FB |
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 2 | Remove covers (6, 7). | Model 223 with code Z07 (B7 armoring on special protection version) |
|
| Fig 1 | |||
| 3 | Remove armrest (2). | AR72.10-P-1035S | |
| Model 223 except code Z07 (B7 armoring on special protection version) |
|||
| 4 | Remove screws (3). | ||
| 5 | Starting from the bottom, unclip door trim (1) and remove from sealing rail. | Do not subject the entire width of the door trim (1) in the area above the door handle to tension and compression. Otherwise, the ambient lighting might be damaged. |
|
Ensure that the retaining clips are seated correctly on the door trim (1). They will be damaged otherwise. |
|||
| Fig 1 | |||
| 6 | Lift door trim (1) until electrical connectors of electrical wiring harness (5) and wire (4) can be accessed. | ||
| 7 | Detach wire (4) of inside door opener. | ||
| 8 | Disconnect electrical connectors at front door control unit and at mid-range speaker. | ||
| 9 | Remove door trim (1). | ||
| Check | |||
| 10 | Check retaining clips of the door trim (1) for damage. | If there is a problem: replace corresponding retaining clip. |
|
| 11 | Install in the reverse order. |