Remove/Install Door Module - AR72.10-P-0900S

Model 223 

except code Z07 (B7 armoring on special protection version) 

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

Shown except code 889 (KEYLESS-GO) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Risk of injury  from contusions to hands if window glass is not secured	Secure window to prevent it from falling down.	AS67.00-Z-0002-01A
	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
Notice	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1	Remove door trim.		AR72.10-P-6575S
2	Release and disconnect electrical connector from mid-range speaker and remove mid-range speaker.
3	Remove grommets (1).
4	Adjust side window (2) until access openings in door module (3) can be accessed.
5	Remove screw (9).	Bolt, power window on window	*BA72.10-P-1008-01BA
6	Press in catch hook (4).	Side window (2) is thus detached from window lifter.
7	Release side window (2) from window lifter, fully slide upwards and secure against falling down.
8	Release and disconnect left front door electrical connector (X35/1x1) or right front door electrical connector (X35/2x1).
9	Guide door wiring harness (5) with grommet (6) out of front door and door module (3).
10	Unscrew screws (7) of door lock.	Screw/bolt, door lock to door	*BA72.10-P-1011-01BA
11	Unscrew screws (8) of door module (3).
12	Remove door module (3) until cable (10) at bearing bracket (11) can be disconnected.	The number of cables (10) can vary depending on equipment installed.
13	Disconnect cable (10) from bearing bracket (11).	The number of cables (10) can vary depending on equipment installed.
14	Release and disconnect electrical connector on bearing bracket (11).	Model 223 with code 889 (KEYLESS-GO) except code Z07 (B7 armoring on special protection version) The number of electrical connectors can vary depending on equipment installed.
15	Remove door module (3).
16	Install in the reverse order.