Remove/Install Rear Door Control Unit - AR72.29-P-1101MFA
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 118, 177, 243, 247
Shown on model 177.0
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 2 | Remove left and right door trim. | AR72.12-P-1011MFA | |
| 3 | Release and disconnect electrical connectors (1) at left rear door control unit (N69/3) and/or right rear door control unit (N69/4). | ||
| 4 | Release lock (2) and remove left rear door control unit (N69/3) and/or right rear door control unit (N69/4) in direction of arrow (A). | ||
| 5 | Install in the reverse order. | ||
| 6 | Perform commissioning of left rear door control unit (N69/3) and/or right rear door control unit (N69/4). | When replacing left rear door control unit (N69/3) or right rear door control unit (N69/4). | |
| AD00.00-P-2000-06MFA |