Remove/Install Rear Door Liner - AR72.12-P-1011MFA
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 118, 177, 247
Model 243.6/7
Shown on mode 177.0
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install | |||
| 1 | Open side window of left and/or right rear door. | ||
| 2 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 3 | Open left/right rear door completely. | ||
| 4 | Remove cover above door trim. | Model 247.0 |
Fig 1 |
| 5 | Remove screw/bolts (2). | ||
| 6 | Unclip door trim (1) all around and lift up until the electrical connectors are accessible. | Do not crush or kink or subject lines to tension. This will result in damage to the lines which may impair their functional capability. |
Fig 2 |
| 7 | Release and disconnect electrical connectors of door trim (1). | ||
| 8 | Unhook wire from inside door opener. | ||
| 9 | Remove door trim (1) at rear door. | ||
| 10 | Install in the reverse order. |