Remove/Install Center Air Vent - AR83.10-P-4509MFA
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 118, 177, 243, 247
MODIFICATION NOTES
| 17.07.2023 | Remove start/stop switch. | Operation step 9. |
Shown on mode 177.0
Shown on model 247.6
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 2 | Unclip trim element (6). | Model 243.6, 247.6 |
Fig 1 |
| 3 | Remove screws (7). | Model 243.6, 247.6 | |
| 4 | Unclip trim element (2) until the electrical connectors are accessible. | Release trim element (2) uniformly from instrument panel. In order to prevent damage. Do not crush or kink or subject electric lines to tension. This will result in damage to the electric lines and can impair their function. The number of electrical connectors varies according to vehicle equipment. |
|
| 5 | Release and disconnect electrical connectors. | ||
| 6 | Remove trim piece (2) and place on a suitable surface. | ||
| 7 | Remove bolts (5). | ||
| 8 | Remove air vents (1) from trim element (2). | ||
| 9 | Remove start/stop switch. | When replacing trim element (2). | AR54.25-P-4000MFA |
| 10 | Install in the reverse order. |