Remove/Install Front Floor Covering On Driver'S Side - AR68.80-P-0007ME
Model 167
MODIFICATION NOTES
| 27.11.2020 | New operation step inserted. | Operation step 12 |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Remove front seat on driver's side. | AR91.10-P-1000ME | |
| 2 | Remove accelerator pedal. | AR30.12-P-1321ME | |
| 3 | Remove floor mat on driver's side at front and rear. | ||
| 4 | Remove door sill on driver's side. | AR68.30-P-4100ME | |
| 5 | Remove trim under instrument panel on driver's side. | AR68.10-P-1501ME | |
| 6 | Unclip air duct trim (1) (arrows) and remove. | ||
| 7 | Lift floor covering (2) at rear end and guide out of lower B-pillar trim. | Fig 1 | |
| 8 | Guide electrical wiring harness (3) through opening in floor covering (2). | ||
| 9 | Guide electric line (5) through opening in floor covering (2). | ||
| 10 | Guide out floor covering (2) under center console (4). | Fig 1 | |
| 11 | Pull floor covering (2) toward rear and remove. | ||
| 12 | Check for correct seat of condensation drain hoses at air conditioner housing and at body opening. | AR83.30-P-5200-03A | |
| 13 | Install in the reverse order. |