Remove/Install Cover On Rear Seat Backrest - AR91.18-P-1872MEA
Model 167.1
except code 567 (Vario rear seat)
Model 167.3
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Remove corresponding seat backrest. | Right rear folding seat backrest | AR91.12-P-1722ME |
| Center rear folding seat backrest | AR91.12-P-1723ME | ||
| Left rear folding seat backrest | AR91.12-P-1724ME | ||
| 2 | Place seat backrest on suitable base. | ||
| 3 | Unclip electrical wiring harness from respective pivot bearing (7). | Model 167.1 with code 872 (Left and right rear seat heating) except code 567 (Vario rear seat) Model 167.3 with code 872 (Left and right rear seat heating) |
|
| 4 | Remove outer pivot bearing (7). | When removing the padding of one of the outer backrests. | |
| *BA91.12-P-1007-03M | |||
| 5 | Remove head restraint guides of seat backrest in rear passenger compartment. | AR91.16-P-1776ME | |
| 6 | Remove belt outlet trim (2). | When the removing the padding of the left backrest. | |
| Fig 1 | |||
| 7 | Remove cover (3) of seat backrest release. | When removing the padding of one of the outer backrests. | |
| Fig 1 | |||
| 8 | Remove corresponding seat backrest trim. | AR91.12-P-1134ME | |
| 9 | Unhook cover (6) at seat backrest frame (4). | Fig 2 | |
| 10 | Loosen seat backrest padding from seat backrest frame (4). | ||
| 11 | Remove seat backrest padding with cover (6). | ||
| 12 | Remove padding from cover (6) of seat backrest padding. | ||
| Fig 3 | |||
| 13 | Install in the reverse order |
REAR SEATS
| Number | Designation | Model 167 | |
|---|---|---|---|
| BA91.12-P-1007-03M | Bolt, pivot bearing to backrest frame | Nm | 40 |