LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2023 >> GLE350 Base >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seats, Bunks, Restraint Systems -- 167 Chassis (1 Of 3) >> Testing & Repair >> Remove/Install Left Rear Folding Seat Backrest - AR91.12-P-1724ME

Remove/Install Left Rear Folding Seat Backrest - AR91.12-P-1724ME

Model 167.1 

except code 567 (Vario rear seat) 

Model 167.3 

G15047339Courtesy of MERCEDES-BENZ USA
G15047340Courtesy of MERCEDES-BENZ USA
Topical note  Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
  Notes on safety-relevant components   AH00.00-Z-0019-01A
REMOVINGINSTALLING Remove/install     
1 Remove seat cushion.   AR91.12-P-1021ME 
2.1 Remove side section (6) at seat backrest. Model 167.1
with code 293 (Side Airbag in rear left and right) except code 567 (Vario rear seat)
Model 167.3
with code 293 (Side Airbag in rear left and right)
 
    IMPORTANT The sidebag unit can remain in the side section. AR91.60-P-0694ME 
2.2 Remove screw (5) and remove side section (6). Model 167.1
except code 293 (Side Airbag in rear left and right)
except code 567 (Vario rear seat)
Model 167.3
except code 293 (Side Airbag in rear left and right)
 
    TORQUE SPECIFICATION Bolt, side section of rear seat backrest to holder *BA91.12-P-1012-03M 
3 Release and disconnect electrical connector (2) and unclip related electric line. Model 167.1
with code 872 (Left and right rear seat heating)
except code 567 (Vario rear seat)
Model 167.3
with code 872 (Left and right rear seat heating)
 
4 Remove screw (4), place left seat belt buckle to one side and guide seat belt end fitting upwards. IMPORTANT The left seat belt buckle and the seat belt end fitting are fastened together with the screw (4).
INSTALLATION IMPORTANT Ensure correct installation position.
 
    TORQUE SPECIFICATION Bolt, rear seat belt buckle *BA91.40-P-1009-01U 
5 Remove screw (3). TORQUE SPECIFICATION Bolt, outer pivot bearing to body *BA91.12-P-1003-03M 
6 Release center seat backrest and fold over.    
7 Release left seat backrest (1) and remover NOTES
Do not tilt left seat backrest (1).
Otherwise, the spacer ring in the left seat backrest (1) may be damaged.
INSTALLATION IMPORTANT Ensure that the spacer ring is correctly seated on the left seat backrest (1).
 
8 Install in the reverse order    
REAR SEATS

Number Designation Model 167
BA91.12-P-1003-03M Bolt, outer pivot bearing to body Nm 50
REAR SEATS

Number Designation Model 167
BA91.12-P-1012-03M Bolt, side section of rear seat backrest to holder M6 Nm 7
SEAT BELTS/EMERGENCY TENSIONING RETRACTORS

Number Designation Model 167
BA91.40-P-1009-01U Bolt, rear seat belt buckle Nm 35