Remove/Install D-Pillar Trim - AR68.30-P-4497MFX

Model 243.6, 247.6 

Courtesy of MERCEDES-BENZ USA

Shown on model 247.6 with code 847 (third row of seats) 

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1	Remove corresponding rear seat of the third row of seats.	Model 243.6, 247.6 with code 847 (3rd seat row)	AR91.12-P-0007MFX
2	Remove seat belt end fitting on the third row of seats.	Model 243.6, 247.6 with code 847 (3rd seat row) Screw/nut, seat belt end fitting/rear seat belt buckle to body	*BA91.40-P-1006-01X
3	Remove trim sideways at the top in the trunk.		AR68.30-P-4805MFX
4	Remove edge guard in the working area.	: Ensure that the edge guard is seated correctly in the working area.
5	Unclip D-pillar trim (1).	Dismantling tool	Fig 1
6	Extend D-pillar trim (1) out of the roof lining and out of the guide (2).	Carefully extend D-pillar trim (1). Otherwise the roof lining will be damaged. : Ensure that the position of the guide (2) is correct.
7	Remove seat belt through the seat belt outlet cover on the D-pillar trim (1).	Model 243.6, 247.6 with code 847 (3rd seat row)
8	Remove D-pillar trim (1).
9	Install in the reverse order.

Fig 1: Identifying Dismantling Tool (000 589 95 63 00)

Courtesy of MERCEDES-BENZ USA