Remove/Install Trim At Upper Side In Trunk - AR68.30-P-4805MFX
Model 243.6, 247.6
Shown on model 247.6 except for code 847 (3rd seat row)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Remove luggage compartment cover. | ||
| 2 | Fold back rear seat. | ||
| 3 | Unclip trim (1). | Ensure that the trim (1) is inserted correctly in the adjacent trims. Damage to adjacent trim can otherwise occur. |
Fig 1 |
| 4 | Release and disconnect electrical connector from multimedia connection unit (A90/5). | Model 247.6 with code 847 (3rd seat row) This will result in damage to the lines which may impair their functional capability. |
|
| 5 | Remove trim (1) in the bottom area toward the inside from the bottom trim and remove trim (1). | ||
| 6 | Remove multimedia connection unit (A90/5). | Model 247.6 with code 847 (3rd seat row) When replacing trim (1). |
|
| 7 | Install in the reverse order. | ||
| 8 | Position edge guard in the working area. |