Remove/Install Side Supplemental Restraint System (SRS) Pressure Sensor - AR91.60-P-0760MFA
Model 118, 177, 243, 247
Shown on model 177.0
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Detach ground line of on-board electrical system battery. | AR54.10-P-0003MFA | |
| 2.1 | Remove front door trim. | When removing the pressure sensor of the driver's door (B48/7) or the pressure sensor of the front passenger door (B48/8). | |
| Model 243 | AR72.10-P-6575EQA | ||
| Model 118, 177, 247 | AR72.10-P-6575MFA | ||
| 2.2 | Remove rear door trim. | When removing the pressure sensor of the rear door at the left (B48/9) or the pressure sensor of the rear door at the right (B48/10). | |
| AR72.12-P-1011MFA | |||
| 3 | Release electrical connector (l) and disconnect. | ||
| 4 | Twist the respective pressure sensor (B48/7, B48/8, B48/9, B48/10) in direction of arrow and remove. | ||
| 5 | Install in the reverse order. | ||
| Check | |||
| 6 | Check Supplemental Restraint System (SRS) using vehicle diagnosis system. | When replacing pressure sensor (B48/7, B48/8, B48/9, B48/10). | |
| AD00.00-P-2000-06MFA |