Remove/Install Rear Door Liner - AR72.12-P-1011MFA

Model 118, 177, 247 

Model 243.6/7 

Courtesy of MERCEDES-BENZ USA

Shown on mode 177.0 

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Open side window of left and/or right rear door.
2	Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).
3	Open left/right rear door completely.
4	Remove cover above door trim.	Model 247.0 Replace damaged retaining clips. Dismantling tool	Fig 1
5	Remove screw/bolts (2).
6	Unclip door trim (1) all around and lift up until the electrical connectors are accessible.	Do not crush or kink or subject lines to tension. This will result in damage to the lines which may impair their functional capability. Long wedge	Fig 2
7	Release and disconnect electrical connectors of door trim (1).	The number of electrical connectors varies according to vehicle equipment.
8	Unhook wire from inside door opener.
9	Remove door trim (1) at rear door.	First lift up front of door trim (1) then remove to the rear. Replace damaged retaining clips (4).
10	Install in the reverse order.

Fig 1: Identifying Dismantling Tool (000 589 95 63 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA