Remove/Install Turbochargers Oil Circuit Feed Line - AR09.40-P-6040MNP
Engine 177 In Model 167
| Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Risk of injury to skin and eyes due to handling of engine oil. Risk of poisoning caused by swallowing engine oil | Wear protective gloves, protective clothing and safety glasses. Do not fill engine oil into beverage containers. |
AS18.00-Z-0001-01A | |
| Topical note | Notes on avoiding damage through contamination and foreign objects | AH00.00-P-5000-01A | |
| Remove/install | |||
| 1 | Remove ignition coil for cylinders 1+2 (T4). | AR15.12-P-2009MNP | |
| 2 | Remove heat shield from exhaust gas turbocharger. | AR09.40-P-6044MNP | |
| 3 | Release heat shield from feed line (1) and place to one side. | ||
| 4 | Clean area surrounding the feed line (1). | Assembly cleaner | *BR00.45-Z-1028-04A |
| 5 | Remove screws (2). | *BA09.40-P-1002-01ZA | |
| 6 | Remove feed line (1) and seal openings with suitable stop plugs. | ||
| Fig 1 | |||
| Fig 2 | |||
| 7 | Install in the reverse order. | ||
| Check | |||
| 8 | Check oil level in the engine and correct if necessary. | ||
| AP18.00-P-1812DKI | |||
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| Risk of burn injuries, suffocation and poisoning when working on the exhaust system and the components connected to it. Risk of suffocation and risk of poisoning caused by inhalation of gaseous and solid components of the exhaust. Risk of poisoning caused by skin contact with solid components of the exhaust. | Wear protective clothing and safety glasses. Use the extraction system. Move people out of the hazard area. | AS49.00-Z-0001-01A | |
| 9 | Perform engine test run. While doing so, check engine for proper operation and leak tightness | ||
| 10 |
Install upper engine cover. | AP01.10-P-2405-01E |
TURBOCHARGER
| Number | Designation | Engine 177 | |
|---|---|---|---|
| BA09.40-P-1002-01ZA | Bolt, oil pressure line to turbocharger/cylinder head | Nm | 9 |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1028-04A | Assembly cleaner | A 000 986 56 01 |