Remove/Install Rear Door - AR72.12-P-0600ME
Model 167
| Risk of injury during testing and repair operations related to pyrotechnical components | Do not expose pyrotechnical component parts to temperatures above 100°C or 212°F. Disconnect current supply when working on such component parts. | AS91.00-Z-0008-01A | |
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Information, assessment and legal requirements when working with, handling and storing pyrotechnical components | AH91.00-Z-0000-10A | ||
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Fully lower side window of rear door (1). | ||
| 2 | Clamp off ground line of on-board electrical system battery (G1). | AR54.10-P-0003ME | |
| 3 | Release and disconnect electrical connector (2). | ||
| 4 | Remove covers (3). | ||
| 5 | Unscrew screw/bolts (4). | Repair paint damage in area of the screws (4). |
|
Bolt at hinge leaf connection |
*BA72.12-P-1005-01K | ||
| 6 | Remove rear door (1) from hinge leafs (5, 6) and set down on suitable base. | Carefully remove rear door (1) and insert. Otherwise paint damage can occur. |
|
| 7 | Install in the reverse order. | ||
| Concluding tasks | |||
| 8 | Check gap dimensions at rear door (1), adjust rear door (1) if necessary. | AR72.12-P-0650ME | |
| 9 | Repair paint damage on respective bolt heads (4). | Overview of MB materials and how they are processed | AR98.00-P-0150CW |
| Risk of explosion and poisoning caused by solvent vapors and gasses. Risk of injury to skin and eyes when working with anticorrosion agents | Never spray corrosion protection on flames or hot, glowing objects and keep them well away from all potential sources of ignition. Use them only in well-ventilated rooms; wear respiratory protection. | AS97.00-Z-0001-01A | |
| 10 | Protect rear door (1) in area of hinge leafs (5, 6) against corrosion; remove excessive wax. | Wax for engine compartment (400 ml spray can) | *BR00.45-Z-1018-05A |
| 11 | Normalize power window assembly. |
REAR DOOR
| Number | Designation | Model 167 | |
|---|---|---|---|
| BA72.12-P-1005-01K | Bolt at hinge leaf connection | Nm | 32 |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1018-05A | Wax for engine compartment (400 ml spray can) | A 000 986 33 70 10 |