Remove/Install Filler Pipe Of Dual-Clutch Transmission - AR27.10-P-0507MFC
Transmission 724.0 in model 118, 177, 247 with engine 260
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Risk of injury . Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil | Wear protective gloves, protective clothing and safety glasses. Do not pour transmission oil into beverage bottles. |
AS00.40-Z-0001-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Notice | Notes on bolted connections with self tapping screws | AH00.00-P-0007-01SF | |
| Notice | Notes on avoiding damage through contamination and foreign objects | AH00.00-P-5000-01A | |
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notice | Notes on self-locking nuts and bolts | AH00.00-P-0001-01KOA | |
| Notes on automatic transmission | AH27.19-P-0001-01NKB | ||
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 2 | Remove engine air intake duct (1) upstream of air filter. | ||
| 3 | Remove charge air hose (2). | AR09.41-P-1311-01AL | |
| 4 | Remove screw (8). | ||
| 5 | Remove bottom engine compartment paneling. | Transmission 724.0 in model 118, 177, 247 with engine 260 with code M016 (Uprated engine) | AR61.20-P-1105MFR |
| Transmission 724.0 in model 118, 177, 247 with engine 260 except code M016 (Uprated engine) compartment paneling after leak test. |
AR61.20-P-1105MFA | ||
| 6 | Release and disconnect electrical connector (3) and place electric line to one side. | ||
| 7 | Unscrew bolt (4). | ||
| 8 | Pull filler pipe (5) out of transmission (6) and remove upwards. | ||
| 9 | Seal openings on transmission (6) and on filler pipe (5) with suitable stop plugs. | Fig 1 | |
| 10 | Install in the reverse order. | ||
| Check | |||
| 11 | Check transmission oil level, correct, if necessary. | AR27.00-P-0104MFC | |
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| Risk of burn injuries , suffocation and poisoning when working on the exhaust system and the components connected to it. Risk of suffocation and risk of poisoning caused by inhalation of gaseous and solid components of the exhaust. Risk of poisoning caused by skin contact with solid components of the exhaust. | Wear protective clothing and safety glasses. Use the extraction system. Move people out of the danger zone. | AS49.00-Z-0001-01A | |
| 12 | Perform engine test run, and check transmission (6) for leak tightness when doing so. |