Update Software For Esp (R) Control Unit (Code: Vs3HOLAPLI, Acc. No.: 32 903 55) - SM42.45-D-0035SG

Model 907 

with code X2R (Bodybuilder requirement: conversion to motorhome) 

Operation no. of the operation texts or standard texts and flat rates
Category	Op. no.	Operation text	Acc. no.	Code
L	02 2443	Operations: Connect/disconnect vehicle diagnosis system	32 903 55	VS3HOLAPLI
L	02 2445	Operations: Connect/disconnect charger (vehicle diagnosis system connected)	32 903 55	VS3HOLAPLI
L	02 2442	Operations: Update .......... control unit software (vehicle diagnosis system connected)	32 903 55	VS3HOLAPLI

	Notes on programming control units		AH54.21-P-0001-03Z
	Check
1	Check whether vehicle is affected by measure.	Affected vehicles: Update software for ESP (R) control unit (code: VS3HOLAPLI, acc. no.: 32 903 55) Model 907.### ## as of 000674 up to 007927 (Bodybuilder requirement: conversion to motorhome) For authorized Mercedes-Benz service partners, only the entry in the Extended VEGA Application (EVA) system, in the "Current" tab, is decisive. An additional test of the affected vehicles in the workshop information system (WIS) or vehicle list is thereby not necessary.	SM42.45-D-0035-01AAA
	Update software
2	Connect charging equipment.
	Maintaining on-board electrical system voltage when performing test and diagnosis work on vehicle	During the entire work procedure a sufficiently large voltage supply must be provided for the vehicle's on-board electrical system. Otherwise any undervoltage that occurs may damage the control units. Follow the operating instructions for the charger. Use the charger to ensure that an adequate power supply (min. 12.5 V) is provided for the on-board electrical system battery.	AR54.10-D-1127TS
3	Connect diagnostic system.
		Always use the latest XENTRY Diagnosis software release. It is absolutely essential to precisely follow the operation steps as described in the vehicle diagnosis system.	AD00.00-D-2000-06TS
4	Update software for ESP® control unit.	It is absolutely essential to precisely follow the operation steps as described in the vehicle diagnosis system.
5	Disconnect diagnostic system.
			AD00.00-D-2000-06TS
6	Remove charger from vehicle.
			AR54.10-D-1127TS