Code Electronic Stability Program (Esp (R)) Control Unit (Code: Vs3COLIBRE, Acc. No.: 42 960 70) - SM42.45-D-0026SG

Model 907 

Operation no. of the operation texts or standard texts and flat rates
Category	Op. no.	Operation text	Acc. no.	Code
L	02 2443	Operations: Connect/disconnect vehicle diagnosis system	42 960 70	VS3COLIBRE
L	02 2445	Operations: Connect/disconnect charger (vehicle diagnosis system connected)	42 960 70	VS3COLIBRE
L	02 2444	Operations: Perform SCN coding in control unit (vehicle diagnosis system connected)	42 960 70	VS3COLIBRE

	Notes on SCN coding of control units		AH54.21-P-0004-01X
	Check
1	Check whether vehicle is affected by measure.	Affected vehicles: Code Electronic Stability Program (ESP (R)) control unit (code: VS3COLIBRE, acc. no.: 42 960 70) Model 907.### ## as of 000264 up to 005502	SM42.45-D-0026-01AAA
	SCN coding
2	Connect diagnostic system.
		Use XENTRY Diagnostics version 05/2018 or higher. It is absolutely essential to precisely follow the operation steps as described in the vehicle diagnosis system.	AD00.00-D-2000-06TS
3	Connect charging equipment.
	Maintaining on-board electrical system voltage when performing test and diagnosis work on vehicle	During the entire work procedure a sufficiently large voltage supply must be provided for the vehicle's on-board electrical system. Otherwise any undervoltage that occurs may damage the control units. Follow the operating instructions for the charger. Use the charger to ensure that an adequate power supply (min. 12.5 V) is provided for the on-board electrical system battery.	AR54.10-D-1127TS
4	Perform SCN coding in Electronic Stability Program (ESP®) control unit.	See process description in diagnostic system "INFO".
5	Disconnect diagnostic system.
			AD00.00-D-2000-06TS
6	Remove charger from vehicle.
			AR54.10-D-1127TS