Update Instrument Cluster Software (Code: Vs3DISPKI, Acc. No.: 54 923 61) - SM54.30-D-0043SG

Model 907

with code E1O (Entry-level radio)

with code JK5 (Instrument cluster with color display)

with code ZU7 (National version for Canada)

Model 907

with code E1O (Entry-level radio)

with code JK5 (Instrument cluster with color display)

with code ZU8 (National version for USA)

Operation no. of the operation texts or standard texts and flat rates
Category	Op. no.	Operation text	Time	Acc. no.	Code
L	02 2443	Operations: Connect/disconnect vehicle diagnosis system	-	54 923 61	VS3DISPKI
L	02 2445	Operations: Connect/disconnect charger (vehicle diagnosis system connected)	-	54 923 61	VS3DISPKI
L	02 2442	Operations: Update control unit software (vehicle diagnosis system connected)	-	54 923 61	VS3DISPKI

	Notes on programming control units		AH54.21-P-0001-03Z
	Check
1	Check whether vehicle is affected by measure.	For authorized Mercedes Benz service partners, only the entry in the Extended VEGA Application (EVA) system, in the "Current" tab is decisive. An additional test of the affected vehicles in the workshop information system (WIS) or vehicle list is thereby not necessary.
	Update software
2	Connect diagnostic system.
		Always use the latest XENTRY Diagnosis software release. It is absolutely essential to precisely follow the operation steps as described in the vehicle diagnosis system.	AD00.00-D-2000.06TS
3	Connect charging equipment.
	Maintaining on board electrical system voltage when performing test and diagnosis work on vehicle		AR54.10-D-1127TS
		During the entire work procedure a sufficiently large voltage supply must be provided for the vehicle's on board electrical system. Otherwise any undervoltage that occurs may damage the control units. Follow the operating instructions for the charger. Use the charger to ensure that an adequate power supply (min. 12.5 V) is provided for the on board electrical system battery.
4	Update instrument cluster (IC) software.	It is absolutely essential to precisely follow the operation steps as described in the vehicle diagnosis system.
5	Disconnect diagnostic system.
			AD00.00-D-2000-06TS
6	Remove charger from vehicle.
			AR54.10-D-1127TS