Update Blind Spot Assist Control Unit Software (Code: Vs3WINKEL, Acc. No.: 54 988 60) - SM54.71-D-0003SG

Model 907.### ## as of 000486 up to 010705

Operation no. of the operation texts or standard texts and flat rates
Category	Op. no.	Operation text	Time	Acc. no.	Code
L	02 2443	Operations: Connect/disconnect vehicle diagnosis system	-	54 988 60	VS3WINKEL
L	02 2445	Operations: Connect/disconnect charger (vehicle diagnosis system connected)	-	54 988 60	VS3WINKEL
L	02 2442	Operations: Update control unit software (vehicle diagnosis system connected)	-	54 988 60	VS3WINKEL

	Notes on programming control units		AH54.21-P-0001-03Z
	Check
1	Check whether vehicle is affected by measure.	Affected vehicles: Update Blind Spot Assist control unit software (code: VS3WINKEL, acc. no.: 54 988 60) For authorized Mercedes-Benz service partners, only the entry in the "Extended VEGA Application" (EVA) system, in the "Current" tab, is decisive. An additional test of the affected vehicles in the workshop information system (WIS) or vehicle list is thereby not necessary.	SM54.71-D-0003-01AAA
	Update software
2	Connect diagnostic system.
		Use XENTRY Diagnostics addon 10041 for version 05/2018 or XENTRY Diagnostics addon 10004 for version 07/2018 or a higher XENTRY Diagnostics version. It is absolutely essential to precisely follow the operation steps as described in the vehicle diagnosis system.	AD00.00-D-2000-06TS
3	Connect charging equipment.
	Maintaining on-board electrical system voltage when performing test and diagnosis work on vehicle	During the entire work procedure a sufficiently large voltage supply must be provided for the vehicle's on-board electrical system. Otherwise any undervoltage that occurs may damage the control units. Follow the operating instructions for the charger. Use the charger to ensure that an adequate power supply (min. 12.5 V) is provided for the on-board electrical system battery.	AR54.10-D-1127TS
4	Update software of Blind Spot Assist control unit.	The control units list in XENTRY Diagnostics specifies separate control units for the left rear bumper radar sensor (B92/24) and the right rear bumper radar sensor (B92/21). When the software of one control unit is updated, the software of the other control unit is automatically updated at the same time. It is absolutely essential to precisely follow the operation steps as described in the vehicle diagnosis system.
5	Disconnect diagnostic system.
			AD00.00-D-2000-06TS
6	Remove charger from vehicle.
			AR54.10-D-1127TS