Remove/Install Roller Sun Blind Guide Rail - AR77.21-P-0231S
Model 223
with code 413 (Panoramic sliding sunroof/glass roof)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Remove sliding roof panel from panoramic sliding sunroof. | AR77.21-P-0007S | |
| 2 | Remove wind deflector. | AR77.21-P-0101S | |
| 3 | Unclip and remove mounting rail (1). | Fig 1 | |
| 4 | Remove roller sunblind motor. | AR77.21-P-0494S | |
| 5 | Remove panoramic sliding sunroof drive unit. | AR77.21-P-1000S | |
| 6 | Remove bolts (2) and bracket (3). | ||
| 7 | Remove bolts (4) and brackets (5). | ||
| 8 | Unclip electrical wiring harness (6) from right guide rail (7) and right bracket (5). | ||
| 9 | Remove screws (8). | ||
| 10 | Lower guide rails (7) and remove from guides with drive cables (9). | ||
| 11 | Pull guide rails (7) upward to remove. | ||
| 12 | Install in the reverse order. |