Remove/Install Wind Deflector For Panoramic Sliding Sunroof - AR77.21-P-0101S
Model 223
with code 413 (Panoramic sliding sunroof/glass roof)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Remove/install | |||
| 1 | Fully open panoramic sliding sunroof. | ||
| 2 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 3 | Release catch hook (arrow) and slide wind deflector (1) towards rear. | ||
| 4 | Unclip wind deflector (1) at front at sliding sunroof frame. | Carefully unclip wind deflector (1). Otherwise damage may occur. |
|
| Fig 1 | |||
| 5 | Fold wind deflector (1) upwards and remove. | ||
| 6 | Install in the reverse order. | ||
| Normalizing | |||
| 7 | Normalize panoramic sliding sunroof with diagnostic system and perform teach-in run for automatic reversing function. | ||
| AD00.00-P-2000-06FR |