Remove/Install Line From Cartridge To Inerting System In Engine Compartment - AR86.10-P-0219LF

Model 217 with engine 157, 176, 177, 276, 278, 279 

Model 222 with engine 157, 176, 177, 256, 276, 277, 278, 279 

with code 2U8 (Alternative refrigerant) 

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove front left fender liner		AR88.10-P-1300LF
2	Remove clamp on pipeline (4) from inerting system cartridge (5)	Replace clamp on pipe (4).
3	Remove pipeline (4) from connection on inerting system cartridge (5)
4	Remove seal (3)
5	Remove trim panel (1) on the right
6	Remove trim panel (2) on left side
7	Remove clamp on pipeline (4) from left engine compartment pipeline (6)	Replace clamp on pipe (4).
8	Remove pipeline (4) from left engine compartment pipeline (6)
9	Remove clamp on pipeline (4) from left engine compartment pipeline (6)	Replace clamp on pipe (4).
10	Remove pipeline (4) from right engine compartment pipeline (6)
11	Expose pipe (4) and remove
	Check
12	Check pipe (4) for damage and plugging	In the event of complaints ↓ Replace pipe (4).
13	Install in the reverse order