Remove/Install Front Door Side Window - AR72.10-P-1961LC
Model 217
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Remove | |||
| 1 | Remove door lining from left or right front door | AR72.10-P-1000LC | |
| 2 | Remove inner sealing rail (1) | Carefully lift inner sealing rail (1) out of bead on inner door panel. Otherwise the inner sealing rail (1) can bend. |
Fig 1 |
| 3 | Unclip control module (2) and lay down to side with lines connected | ||
| 4 | Unclip cover (3) | ||
| 5 | Remove screw/bolt (4) | ||
| 6 | Unclip cover (6) | ||
| 7 | Connect electrical wiring harness on removed door lining to left front door control unit and right front door control unit | ||
| 8 | Raise right or left side window until bolts (5) are accessible | ||
| 9 | Disconnect electrical wiring harness on removed door lining from left front door control unit or right front door control unit | ||
| 10 | Remove screw/bolts (5) | ||
| 11 | Remove right or left side window upward | ||
| Install | |||
| 12 | Insert right or left side window | ||
| 13 | Position bolts (5) | ||
| 14 | Adjust right or left side window | AR72.10-P-1960LC | |
| 15 | Fully tighten bolts (5) | *BA72.10-P-1007-01X | |
| 16 | Connect electrical wiring harness on removed door lining to left front door control unit and right front door control unit | ||
| 17 | Move side window down | ||
| 18 | Disconnect electrical wiring harness on removed door lining from left front door control unit or right front door control unit | ||
| 19 | Clip in cover (6) | ||
| 20 | Tighten bolt (4) | ||
| 21 | Clip in cover (3) | ||
| 22 | Clip in control module (2) | ||
| 23 | Install inner sealing rail (1) | Lubricant, rubber assembly 1 l |
*BR00.45-Z-1010-06A |
| 24 | Install door lining | AR72.10-P-1000LC | |
| 25 | Leave left or right side window up | ||
| 26 | Check for proper function and synchronize power window |
FRONT DOOR
| Number | Designation | Model 217 | |
|---|---|---|---|
| BA72.10-P-1007-01X | Bolt, side window to power window rail | Nm | 13 |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1010-06A | Lubricant, rubber assembly 1 l | A 000 989 03 67 |