LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2021 >> S560 4Matic >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Electrical System - Body - 217 Chassis (4 Of 7) >> Testing & Repair >> Remove/Install Radio, Central Locking And Keyless-Go Antenna Amplifier >> Remove/Install Radio, Central Locking And Keyless-Go Antenna Amplifier - AR82.62-P-8307LF

Remove/Install Radio, Central Locking And Keyless-Go Antenna Amplifier - AR82.62-P-8307LF

Model 217.3, 222 

MODIFICATION NOTES

04.12.2019 Document completely revised.    
G15346781Courtesy of MERCEDES-BENZ USA

Shown on MODEL 222 with CODE 413 (Panoramic sliding roof) 

G15346782Courtesy of MERCEDES-BENZ USA

Shown on MODEL 222 with CODE 413 (Panoramic sliding roof) 

CAUTION Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.
AS00.00-Z-0017-01A
Topical note Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
Topical note Notes on preventing damage to electronic components due to a magnetic tool   AH54.00-P-0002-01A
  Remove, install FM, AM, ZV, DAB and KEYLESS-GO (A2/18) antenna amplifier     
1.1 Remove roof lining service flap (7). Model 222.9
except code Z07 (B7 armoring on special protection version)
 
1.2 Remove rear section of roof lining. Model 222.9
with code Z07 (B7 armoring on special protection version)
AR68.30-P-4307LFS
2 Release and disconnect electrical connectors (2). NOTES
Avoid strain relief on electrical lines.
Otherwise there will be damage to the contact strips.
 
3 Loosen screw/bolt (1). IMPORTANT The screw/bolt (1) remains in the FM, AM, ZV, DAB and KEYLESS-GO (A2/18) antenna amplifier.  
4 Unclip and remove the FM, AM, ZV, DAB and KEYLESS-GO (A2/18) antenna amplifier.    
5 Install in the reverse order.    
  Remove/install FM 2 and DAB antenna amplifier (A2/19)     
6 Remove trim at left from C-pillar. Model 217.3 AR68.30-P-4490LC
    Model 222.0/1 AR68.30-P-4490LF
    Model 222.9 AR68.30-P-4490LFA
7 Release and disconnect electrical connectors (2). NOTES
Avoid strain relief on electrical lines.
Otherwise there will be damage to the contact strips.
 
8 Loosen screw/bolt (1). IMPORTANT The screw/bolt (1) remains in the FM 2 and DAB (A2/19) antenna amplifier.  
9 Unclip and remove FM 2 and DAB (A2/19) antenna amplifier.    
10 Install in the reverse order.