Remove/Install Battery Sensor Of Secondary 12 V On-Board Electrical System - AR54.10-P-0060S

Model 223 

with code 200 (Conditionally automated driving) 

Model 223 

with code 503 (Remote-controlled parking) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
Notice	Notes on battery		AH54.10-P-0001-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A
	Remove/install
1	Disconnect ground line of secondary 12 V onboard electrical system battery.		AR54.10-P-0052S
2	Disconnect electrical connector (1).
3	Remove ground line (2) of battery sensor (B95/3) from body.	Model 223 with code 200 (Conditionally automated driving) except code Z07 (B7 armoring on special protection version) Powerpack ground point, tml.31 RHD vehicle	*BA00.19-P-1046-01N
		Model 223 with code 200 (Conditionally automated driving) except code Z07 (B7 armoring on special protection version) Powerpack ground point, tml.31 LHD vehicle	*BA00.19-P-1001-01N
4	Remove ground line with battery sensor (B95/3).	The ground line (2) and battery sensor (B95/3) are one component part and cannot be replaced individually.
5	Install in the reverse order.
6	Commission battery sensor (B95/3).	When replacing battery sensor (B95/3).
			AD00.00-P-2000-06FR