Remove/Install Side Supplemental Restraint System (SRS) Pressure Sensor - AR91.60-P-0760S
Model 223
Shown on left front door
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1.1 | Remove corresponding door trim on front door. | When removing side impact protection pressure sensor (B48/7, B48/8). | AR72.10-P-6575S |
| 1.2 | Remove corresponding door trim on rear door. | When removing side impact protection pressure sensor (B48/9, B48/10). | AR72.12-P-1011S |
| 2 | Disconnect ground line of battery of 12 V on-board electrical system. | AR54.10-P-0051S | |
| 3 | Disconnect electrical connector (1). | ||
| 4 | Turn side impact protection pressure sensor (B48/7, B48/8, B48/9, B48/10) through 90° counterclockwise and remove. | ||
| 5 | Install in the reverse order. | ||
| Check | |||
| 6 | Check Supplemental Restraint System (SRS) using vehicle diagnosis system. | ||
| AD00.00-P-2000-06FR |