Remove/Install Side Supplemental Restraint System (SRS) Acceleration Sensor - AR91.60-P-0734S
Model 223
MODIFICATION NOTES
| 11.10.2023 | Screw, side airbag and window airbag sensor to B-pillar | Model 223 | BA91.60-P-1008-01I |
Fig 1: Side Supplemental Restraint System (SRS) Acceleration/Crash Sensor Components Location - Model 223
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Disconnect ground line of battery of 12 V on-board electrical system. | AR54.10-P-0051S | |
| 2 | Remove corresponding lower B-pillar trim. | Model 223 Model 223 except code Z07 (B7 armoring on special protection version) |
AR68.30-P-4700S |
| 3 | Disconnect electrical connector from crash sensor (B48/15, B48/16). | ||
| 4 | Remove screw (1). | *BA91.60-P-1008-01I | |
| 5 | Remove crash sensor (B48/15, B48/16). | ||
| 6 | Install in the reverse order. | ||
| Check | |||
| 7 | Check Supplemental Restraint System (SRS) using vehicle diagnosis system. | ||
| AD00.00-P-2000-06FR |
AIRBAG
| Number | Designation | Model 223 | |
|---|---|---|---|
| BA91.60-P-1008-01I | Screw/bolt, side airbag and window airbag sensor to B-pillar | Nm | 10 |