LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2021 >> S500 >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Electrical System, Equipment & Instruments (2 Of 3) -- 223 Chassis >> Testing & Repair >> Remove/Install Parking System Control Unit - AR54.65-P-0018S

Remove/Install Parking System Control Unit - AR54.65-P-0018S

Model 223 

G16191680Courtesy of MERCEDES-BENZ USA

Shown with code 97B (Engine noise reduction via speakers (EOC)) and with code 406 (Multicontour seats in rear passenger compartment) 

G16191681Courtesy of MERCEDES-BENZ USA

Shown with code 224 (Individual rear seat system design) and with code 811 (High-end sound system) 

Shown with code 233 (Adaptive cruise control plus (DISTRONIC PLUS)) 

G16191682Courtesy of MERCEDES-BENZ USA
G16191683Courtesy of MERCEDES-BENZ USA
Notice  Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
  Notes on safety-relevant components   AH00.00-Z-0019-01A
REMOVINGINSTALLING Remove/install     
1 Switch off ignition and store transmitter key outside of transmission range (min. 2 m).    
2 Remove trim in the left side of the luggage compartment. Model 223
with code Z07 (B7 armoring on special protection version)
AR68.30-P-4800SG
    Model 223
except code Z07 (B7 armoring on special protection version)
AR68.30-P-4800S
3 Remove subwoofer. Model 223
with code 811 (High-End sound system)
AR82.62-P-7841S
4 Disconnect electrical connectors from sound generator control unit (N156/1). Model 223
with code 97B (Engine noise reduction via speakers (EOC))
 
5 Remove holder (1) and place to one side with connected lines. Model 223
with code 810 (Premium sound system)
Model 223
with code 811 (High-End sound system) Model 223
with code 854 (Rear Seat Entertainment System Plus)
Model 223
with code 97B (Engine noise reduction via speakers (EOC))
 
6 Remove damping (2) over pneumatic pump. Model 223
with code 406 (Multicontour rear seat)
Model 223
with code 432 (Dynamic seats left and right)
 
7 Remove pneumatic pump with connected lines. Model 223
with code 406 (Multicontour rear seat)
Model 223
with code 432 (Dynamic seats left and right)
 
8 Remove the bracket (3). Model 223
with code 406 (Multicontour rear seat)
Model 223
with code 432 (Dynamic seats left and right)
Model 223
with code 878 (CONNECTED LIGHT ambient lighting)
 
9 Remove sound control unit. Model 223
with code 810 (Premium sound system)
Model 223
with code 811 (High-End sound system)
AR82.62-P-7724S
10 Unclip electric lines from holder (4) and remove holder (4) with connected control units and place to one side.    
11 Remove holder (5) with connected control units and place to one side. Model 223
with code 233 (Adaptive cruise control Plus (DISTRONIC PLUS))
 
12 Unclip connection piece (6) from trunk lid drive unit (7). Model 223
with code 881 (Remote boot-lid closing)
 
13 Expose electric lines at holder (8) and remove holder (8) with connected control units and place to one side. Model 223
with code 223 (Electric backrest adjustment and head restraints)
Model 223
with code 224 (Rear individual seat design)
Model 223
with code 380 (Car telephony package)
with code 503 (Remote-controlled parking)
Model 223
with code 380 (Car telephony package)
with code 896 (Vehicle access and authorization via smartphone)
Model 223
with code 453 (Rear reclining seat)
Model 223
with code 503 (Remote-controlled parking)
with code 896 (Vehicle access and authorization via smartphone)
Model 223
with code 881 (Remote boot-lid closing)
Model 223
with code 906 (Front armrest heater)
Model 223
with code 907 (Rear armrest heater)
Model 223
with code B24 (Remote control for Auxiliary heating)
 
14 Remove screws (9) and guide parking system control unit (N62/3) out downwards with holder.    
15 Disconnect electrical connectors from parking system control unit (N62/3).    
16 Remove holder from parking system control unit (N62/3). Only when replacing the parking system control unit (N62/3).  
17 Install in the reverse order.    
18 Commission parking system control unit (N623). Only when replacing the parking system control unit (N62/3).  
REFER TO SELF-DIAGNOSTIC SYSTEMS     AD00.00-P-2000-06FR