LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2021 >> S500 >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> Electrical System, Equipment & Instruments (3 Of 3) -- 223 Chassis >> Retrofitting & Conversion >> Retrofit Alcohol Breathalyzer - AZ54.21-P-0011S

Retrofit Alcohol Breathalyzer - AZ54.21-P-0011S

Model 223 

as of model year 2023 

G16195988Courtesy of MERCEDES-BENZ USA

Alcohol breathalyzer installation areas 

Notice  Notes on retrofitting electrical/optical lines   AH82.00-P-0000-01A
  Notes on retrofitting an alcohol breathalyzer   AH54.21-P-0001-08A
REMOVING Remove     
1 Expose rear signal acquisition and actuation module control unit (N10/8).    
REFER TO TESTING & REPAIR     AR54.21-P-1269S
REFER TO BASIC KNOWLEDGE Cab signal acquisition and actuation module control unit (SCA), component description   GF54.21-P-0007A
2 Expose fuse and relay module (F152/1).    
REFER TO TESTING & REPAIR     AR54.15-P-0003S
REFER TO BASIC KNOWLEDGE 12 V on-board electrical system fuse and relay module, component description   GF54.15-P-0006A
3.1 Expose left front footwell ground point (W85/1). Model 223.### 1#
IMPORTANT For location of the left front footwell ground point (W85/1), see Dynamic Wiring Diagram (DWD).
https://xentry.mercedes-benz.com/home/ 
 
3.2 Expose right front footwell ground point (W85/2). Model 223.### 2#
IMPORTANT For location of the right front footwell ground point (W85/2), see Dynamic Wiring Diagram (DWD).
https://xentry.mercedes-benz.com/home/ 
 
INSTALLING Install     
4 Retrofit alcohol breathalyzer. IMPORTANT Observe installation documentation from manufacturer of alcohol breathalyzer.
For wiring diagrams, see Dynamic Wiring Diagram (DWD).
https://xentry.mercedes-benz.com/home/ 
IMPORTANT Electrical connection of alcohol breathalyzer: Left front footwell ground point (W85/1) or right front footwell ground point (W85/2) with line connector A 002 546 74 40 to existing line, on fuse and relay module (F152/1) in fuse F205 with contact A 013 545 75 26 and fuse 10 A and on rear signal acquisition and actuation module control unit (N10/8) in plug RB3, pin 28 with contact A 005 545 75 26.
 
5 Install remaining parts.    
  Update Vehicle Documentation (VeDoc)     
6 Attach "Alcohol breathalyzer retrofitted as per AZ54.21-P-0011S" note under field organization texts for DG 54.    
  Initial startup     
7 Connect diagnostic system.    
REFER TO SELF-DIAGNOSTIC SYSTEMS     AD00.00-P-2000-06FR
8 Activate alcohol breathalyzer. IMPORTANT In the EIS [EZS] control unit  menu:
Adaptation →
Configuration →
Manual setting
 
9 Disconnect diagnostic system.    
REFER TO SELF-DIAGNOSTIC SYSTEMS     AD00.00-P-2000-06FR
10 Carry out operational check.