Remove/Install Active Driving Sound Compensation Control Unit - AR54.21-P-0061S
Model 223
with code 97B (Engine noise reduction via speakers (EOC))
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
| 2 | Remove trim in the left side of the luggage compartment. | Model 223 | AR68.30-P-4800S |
| with code 97B (Engine noise reduction via speakers (EOC)) except code Z07 (B7 armoring on special protection version) |
|||
| 3 | Remove subwoofer. | AR82.62-P-7841S | |
| Model 223 with code 811 (High-End sound system) with code 97B (Engine noise reduction via speakers (EOC)) |
|||
| 4 | Release and disconnect electrical connections (1). | ||
| 5 | Remove nuts (2) and remove active driving sound compensation control unit (N156/1). | ||
| 6 | Install in the reverse order. | ||
| 7 | Commission active driving sound compensation control unit (N156/1). | When replacing the active driving sound compensation control unit (N156/1). | |
| AD00.00-P-2000-06FR |