Update Software Of Radio (Code: VS2APLAYLI) - SM82.60-S-0031A

Model 447.6##/7## ## as of 687601 up to 790228

with code E3C (Audio 30)

with code XZ1 (Model generation 1)

Model 447.6##/7## ## as of 687601 up to 790228

with code EA4 (Audio 40)

with code XZ1 (Model generation 1)

MODIFICATION NOTES

13.05.2021

Repair method changed.

OPERATION NO. OF OPERATION TEXTS OR STANDARD TEXTS AND FLAT RATES

Category	Op. no.	Operation text	Time	Acc. no.	Code
P	02 1020	Operations: Update radio software	-	82 951 53	VS2APLAYLI

	Check
1	Check if vehicle is affected by measure.	Affected vehicles: Update software of radio (code: VS2APLAYLI) For authorized Mercedes-Benz service partners, only the entry in the "Extended VEGA Application" (EVA) system, in the "Current" tab is decisive. An additional test of the affected vehicles in the workshop information system (WIS) or vehicle list is thereby not necessary.	SM82.60-S-0031-01AAA
	Update software
2	Install the 12 V charger.
		During the entire work procedure a sufficiently large voltage supply must be provided for the vehicle's on-board electrical system. Otherwise any undervoltage that occurs may damage the control units. Follow the operating instructions for the 12 V charger. Use the charger to ensure that an adequate power supply (min. 12.5 V) is provided for the onboard electrical system battery	AR54.10-S-1127E
3	Install vehicle diagnosis system.	If XENTRY Diagnosis is not yet attached.
			AD00.00-S-2000-04E
	Service Information: Regio DVD and Retail Data Storage	Always use the latest XENTRY Diagnosis software. For further information on Retail Data Storage, see service information above. It is essential to follow the operation steps in the diagnostic system. If XENTRY Diagnosis is already connected to vehicle, ↓ continue with operation step 4.	SI00.01-D-0044SG
4	Update software for radio/radio navigation (N87/15).
		To do this, select the following menu items: Quick test view → N87/15 - Radio/Radio - Navigation (RD) (Code: E3C, EA4) → Adaptations → Control units update → Updating of control unit software You are then automatically guided through the steps "Updating of control unit software" and "SCN coding". It is essential to follow the operation steps in the diagnostic system.	AR54.21-S-0014E
5	Remove vehicle diagnosis system from vehicle.
6	Remove the 12 V charger from vehicle.
			AR54.10-S-1127E