Remove/Install Upper Guide Rail For Sliding Door - AR72.16-S-7811E

Model 447, 448 

Shown On model 447.8 With Code SH8 (window airbag for driver, front passenger and rear passenger compartment) 

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

Shown On model 447.6 

	Risk of injury  caused by performing testing or repair work on airbag or emergency tensioning retractor units.	Store airbag units with deployment side facing up; do not expose to temperatures greater than 100°C. When working on these units, disconnect the power supply.	AS91.00-Z-0001-01A
	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
Notice	Notes on carrying out repair work in the vehicle interior		AH68.00-D-0001-01KOS
Notice	General information on vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system as well as personal protective equipment	Model 447 with engine 780	AH00.00-Z-0300-01A
	Remove/install
1	Remove rear roof lining.	Model 447.7 with code V23 (Interior trim, premium version) with code ZH6 (Marco Polo ACTIVITY)	AR68.30-S-7608EA
		Model 447.7 with code V23 (Interior trim, premium version) except code ZH6 (Marco Polo ACTIVITY) Model 447.8 except code ZK7 (Equipment line MARCO POLO) Model 448.7 with code V23 (Interior trim, premium version) Model 448.8	AR68.30-S-7608E
		Model 447.8 with code ZK7 (Equipment line MARCO POLO)	AR68.30-S-7608EE
2	Detach the seal (4) from the body at both ends.
3	Move the seal (4) downward to remove.	replace seal (4).
4	Remove upper carriage sliding door.		AR72.16-S-7842E
5	Remove nut (2).	Nut, sliding door guide rail to roof	*BA72.16-Z-1015-01KOJ
6.1	Remove nuts (3).	Model 447, 448 except code SH8 (Window airbags for driver, front passenger and rear) Nut, sliding door guide rail to roof	*BA72.16-Z-1015-01KOJ
6.2	Carefully press the window airbag (1) to the side and remove the nuts (3).	Model 447.7/8, 448 with code SH8 (Window airbags for driver, front passenger and rear) Nut, sliding door guide rail to roof	*BA72.16-Z-1015-01KOJ
7	Remove the upper guide rail (5).	Carefully remove upper guide (5). Otherwise the paint can be damaged.
8	Install in the reverse order.
	Check
9	Check the sliding door to ensure that it functions properly.