Remove/Install Obstruction Sensor Strip For Electric Sliding Door - AR72.29-S-5890E
Model 447.7/8, 448.8
With Code T56 (Electric operation of sliding door on left)
Model 447.7/8, 448
With Code T55 (Electric operation of sliding door on right)
Fig 1: Obstruction Sensor Strip For Electric Sliding Door Components Location - Model 447.7 With Code T56, T55
Shown On removed sliding door
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Remove/install | |||
| 1 | Remove door trim of respective sliding door | AR72.16-S-6610E | |
| 2 | Remove sliding door trim | ||
| 3 | Detach cable tie (1) and disconnect electrical connector (2) | ||
| 4 | Remove retaining clips (3) and remove right front edge on sliding door anti-pinch protection (B51/7) or left front edge of sliding door anti-pinch protection (B51/8) | ||
| 5 | Install in the reverse order | ||
| Check | |||
| 6 | Check anti-pinch protection of sliding door for proper function |