Remove/Install Hinge For Pop-Out Window Of Liftgate - AR72.20-S-2655E

Model 447, 448 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Remove/install
1	Open vent window (4)
2	Mark installation position of hinge (1) on vent window (4) and liftgate (5)
3	Unscrew nuts (3) from left and right hinge (1)	Helper required. Change hinges (1) one after another. Observe corresponding markings. Nut, hinge to pop-out window	*BA72.20-Z-1016-03KOJ
4	Unscrew bolt (2) and remove corresponding hinge (1)	Helper required. Observe corresponding markings. Bolt, hinge for pop-out window to liftgate	*BA72.20-Z-1017-03KOJ
5	Install in the reverse order
	Check
6	Check gap dimension "HB" between vent window (4) and liftgate (5)	Gap dimensions Adjust gap dimensions	*BE60.00-Z-1008-01KOJ
		Feeler gauge In the event of complaints: ↓ Adjust gap dimension "HB".	Fig 1
		Nut, hinge to pop-out window	*BA72.20-Z-1016-03KOJ
		Bolt, hinge for pop-out window to liftgate	*BA72.20-Z-1017-03KOJ

ADJUST GAP DIMENSIONS

Number	Designation				Model 447, 448 with code W64, W65, W68
BE60.00-Z-1008-01KOJ	Adjust gap dimensions	Rear window in liftgate, all-round	Dimension "HA"	mm	4 (±1)
		Folding rear window in liftgate, all-round	Dimension "HB"	mm	4 (±1)
		Liftgate to tail lamp	Dimension "HC"	mm	4, 5 (±1)
		Liftgate to bumper at side	Dimension "HD"	mm	4 (±1)
		Liftgate to bumper at bottom	Dimension "HE"	mm	6 (±1, 5)
		Liftgate to roof frame	Dimension "HF"	mm	5, 5 (±1)
			For picture, see		AR60.00-S-0700-01E

LIFTGATE

Number	Designation		Model 447, 448
BA72.20-Z-1016-03KOJ	Nut, hinge to pop-out window	Nm	6

LIFTGATE

Number	Designation		Model 447, 448
BA72.20-Z-1017-03KOJ	Bolt, hinge for pop-out window to liftgate	Nm	23

Fig 1: Identifying Feeler Gauge (129 589 03 21 00)

Courtesy of MERCEDES-BENZ USA