Remove/Install Front Door Window - AR72.10-S-1910E
Model 447
Model 448
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Risk of injury from contusions to hands if window glass is not secured | Secure window to prevent it from falling down. | AS67.00-Z-0002-01A | |
| Notice | Notes on carrying out repair work in the vehicle interior | AH68.00-D-0001-01KOS | |
| Remove | |||
| 1 | Remove door liner on front door | AR72.10-S-6575E | |
| 2 | Remove grommets (1) from door module | ||
| 3 | Open window (4) until bolts (2) are accessible through assembly openings in door module | ||
| 4 | Loosen bolts (2) until window (4) can be removed from brackets on power window | ||
| 5 | Adjust power window to lower end position | ||
| 6 | Tilt window (4) at rear in direction of arrow and remove upward from window channel on front door | ||
| Install | |||
| 7 | Install window (4) in window channel of front door and tilt opposite direction of arrow | ||
| 8 | Open power window until bolts (2) are accessible through assembly openings in door module | ||
| 9 | Install window (4) in bracket on power window | ||
| 10 | Screw in bolts (2) several turns | ||
| 11 | Slightly press window (4) down and in direction of A-pillar and tighten bolts (2) | *BA72.10-Z-1007-01KOG | |
| Check | |||
| 12 | Check power window for proper function | ||
| Install | |||
| 13 | Install grommets (1) in door module | ||
| 14 | Install front door paneling | AR72.10-S-6575E |
FRONT DOOR
| Number | Designation | Model 447, 448 | |
|---|---|---|---|
| BA72.10-Z-1007-01KOG | Bolt/nut for attachment of side window to window lifter | Nm | 6 |