Remove/Install Rear Camber Strut - AR35.20-P-0110ME
Model 167
Shown on left side of vehicle
| Notice | Notes on threaded connections fastened using a tightening angle-based tightening process | AH00.00-P-0020-01A | |
| Notice | Notes on self-locking nuts and bolts | AH00.00-P-0001-01KOA | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Notes on repair work on suspension components | AH00.00-P-0100-01A | ||
| Remove/install | |||
| 1 | Remove right or left rear wheel and tire assembly. | AR40.10-P-1102ME | |
| 2 | Unclip cable bracket (2) with electrical wiring harness from camber strut (1) and place to one side. | Do not stretch, crush or kink the electrical wiring harness. This will result in damage to the electrical wiring harness and can impair its function. |
|
| 3 | Unscrew nut (3) and remove screw (4). | *BA35.20-P-1001-02F | |
| Fig 2 | |||
| Fig 3 | |||
| 4 | Unscrew nut (5) and remove screw (6). | *BA35.20-P-1002-02F | |
| 5 | Remove camber strut (1). | ||
| Check | |||
| 6 | Check camber strut (1) for damage. | If damage is present, ↓ Replace camber strut (1). |
|
| 7 | Install in the reverse order. | ||
| Finishing activity | |||
| 8 | Perform chassis alignment. | AR40.20-P-0200ME |
CAMBER STRUT
| Number | Designation | Model 167 | |
|---|---|---|---|
| BA35.20-P-1001-02F | Self-locking nut, camber strut to rear axle carrier | Nm | 90 |
CAMBER STRUT
| Number | Designation | Model 167 | ||
|---|---|---|---|---|
| BA35.20-P-1002-02F | Self-locking nut, camber strut to wheel carrier | Stage 1 | Nm | 80 |
| Stage 2 | ∠° | 90 | ||