Remove/Install Front Panoramic Roof Roller Sun Blind - AR77.21-P-0200FRX

Model 290 with code 416 (Panoramic sunroof) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Remove/install
1	Completely open roller sunblind.
2	Remove engine for the roller sunblind of the panoramic roof.		AR77.21-P-0491FRX
		When installing the engine for the panoramic roof roller sunblind, ensure that the roller sunblinds are completely open.
3	Release drive cable guide tube (1) and turn downward to a vertical position.
4	Release guides from the brackets (2) and push rear roller sunblind up to end stop toward the rear.
5	Detach drive cable guide tube (1) from the drive cables.
6	Remove screw/bolts (3).
7	Remove screws (4) and remove roof lining brackets (5).
8	Remove front roller sunblind (6) with the drive cables.	Lubricate drive cables with synthetic grease during assembly.
		Synthetic grease, sliding roof 500 g, DB supply specification 6827.60	*BR00.45-Z-1004-06A
9	Install in the reverse order.
	Check
10	Perform function test of the systems that have influenced the previous work procedure.

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1004-06A	Synthetic grease, sliding roof 500 g, DB supply specification 6827.60	A 001 989 46 51