Remove/Install Rear Seat Cushion Cover - AR91.18-P-1851FRY

Model 290 

except code 568 (3-seater rear bench seat) 

Courtesy of MERCEDES-BENZ USA

Shown on model 290, except code 224 (Design individual rear seat system) 

	Remove
1	Remove seat cushion in rear passenger compartment.		AR91.12-P-1021FRX
2	Unclip ISOFIX covers.	First unclip ISOFIX coverings from the lower brackets, and then guide out of upper brackets.
3	Unhook terminal strips of cover (1) all-round from seat cushion padding (2).	Extraction hook	Fig 2
4	Pull cover (1) over seat cushion padding (2).
5	Release staple wires (3) at attachment points (4).		AR91.18-P-1851-01FRX
		Padding clip pliers	Fig 3
		Dismantling tool	Fig 1
6	Remove cover (1) from seat cushion padding (2).
	Install
7	Align cover (1) over seat cushion padding (2) so that the seams locate in the notches of the seat cushion padding (2).
8	Fasten staple wires (3) at attachment points (4).		AR91.18-P-1851-01FRX
		Padding clip pliers	Fig 3
		Dismantling tool	Fig 1
9	Pull cover (1) over seat cushion padding (2).
10	Hook terminal strips of cover (1) all-round into seat cushion padding (2).	Extraction hook	Fig 2
11	Clip-in ISOFIX covers.
12	Install seat cushion in rear.		AR91.12-P-1021FRX

Fig 1: Identifying Dismantling Tool (205 589 03 63 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Extraction Hook (140 589 02 33 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Padding Clip Pliers (454 589 03 37 00)

Courtesy of MERCEDES-BENZ USA