Remove/Install Side Load Compartment Paneling - AR68.30-P-1185FRX

Model 290 

Courtesy of MERCEDES-BENZ USA

Shown on right side of vehicle 

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A
	Remove/install
1	Remove top side load compartment trim.	Do not remove seat belt end fitting.	AR68.30-P-1186FRX
2	Remove upper rear-end center-section trim.		AR68.30-P-4787FRX
3	Remove load compartment floor front section.		AR68.80-P-0010FRX
4	Remove retaining clip (2).
5	Unclip load compartment trim (1) from the rear to the front from retaining clips (arrows) and remove until electrical connectors can be accessed.	Ensure that sealing frame is seated correctly on liftgate.
6	Disconnect electrical connector at load compartment trim (1).	The number of electrical connectors can vary depending on the vehicle equipment.
7	Remove load compartment trim (1).
8	Install in the reverse order.