Remove/Install TV Tuner Control Unit - AR82.85-P-7366FRX
Model 290 with code 865 (digital TV)
Shown with code 550 (Trailer hitch) and with code U67 (230 volt socket in vehicle interior)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Topical note | Notes on avoiding damage to optical fibers during repair work | AH82.60-P-0001-05AK | |
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Commission TV tuner control unit (N143). | When replacing the TV tuner control unit (N143). | |
| AD00.00-P-2000-06FR | |||
| 2 | Remove right load compartment cover. | AR68.30-P-1185FRX | |
| 3 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
| 4 | Remove holder (1) and set aside with control units attached. | ||
| 5 | Disconnect electrical connectors from TV tuner control unit (N143) and cover up fiber-optic cables. | ||
| 6 | Unscrew bolts (2). | ||
| 7 | Remove TV tuner control unit (N143) from bracket (1). | ||
| 8 | Install in the reverse order. |