Remove/Install Sound System Control Unit - AR82.62-P-7724FRX
Model 290 with code 810 (Premium sound system)
Model 290 with code 811 (High-End sound system)
Shown with code 811 (Advanced sound system)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Topical note | Notes on avoiding damage to optical fibers during repair work | AH82.60-P-0001-05AK | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Perform commissioning of sound system amplifier control unit or advanced sound system amplifier control unit (N40/7). | When replacing sound system amplifier control unit or advanced sound system amplifier control unit (N40/7). | |
| AD00.00-P-2000-06FR | |||
| 2 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
| 3 | Remove side trim in left load compartment. | AR68.30-P-1185FRX | |
| 4 | Release and disconnect electrical connections (1). | with code 810 (Premium sound system) |
|
| Only one electrical connector (1) is installed. | |||
| 5 | Disconnect electrical connector with fiber-optic cable (2). | ||
| 6 | Cover plug of electrical connector with fiber-optic cable (2) and equipment connection on sound system amplifier control unit or on advanced sound system amplifier control unit (N40/7). | ||
| 7 | Unscrew nuts (3) and remove sound system amplifier control unit or advanced sound system amplifier control unit (N40/7). | ||
| 8 | Install in the reverse order. |