Remove/Install Bass Speaker Amplifier - AR82.62-P-7719FRX
Model 290 with code 811 (High-End sound system)
MODIFICATION NOTES
| 12.07.2023 | Commission rear bass speaker amplifier (N40/14). | Operation step 6. |
Shown on model 290 up to model year 2023
Shown on model 290 from model year 2023
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
| 2 | Remove side trim in left load compartment. | AR68.30-P-1185FRX | |
| 3 | Release and disconnect electrical connections (1). | ||
| 4 | Remove screws (2) and remove rear bass speaker amplifier (N40/14). | ||
| 5 | Install in the reverse order. | ||
| 6 | Commission rear bass speaker amplifier (N40/14). | When replacing rear bass speaker amplifier (N40/14). | |
| AD00.00-P-2000-06FR |