Remove/Install Center Liftgate Trim - AR72.20-P-6618ME
Model 167
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Remove bottom liftgate trim. | AR72.20-P-6617ME | |
| 2 | Unclip center liftgate trim (1). | Ensure that the guides (3) and retaining clamps (4) are positioned correctly. Otherwise, the center liftgate trim (1) will be damaged. |
Fig 1 |
| Check | |||
| 3 | Check retaining clips (2) and retaining clamps (4) for damage. | If there is a problem, ↓ replace corresponding retaining clip (2) and corresponding retaining clamps (4). |
|
| 4 | Install in the reverse order. |